Here is a short build log with pictures and components installed.

I started building wings first. Pictures are louder than words.

Photobucket

Photobucket

Photobucket

Photobucket

Photobucket

Photobucket

Covering wing joint with glass cloth and gluing with some epoxy.

Photobucket

Applying lacquer and sanding. I have made three layers.

Photobucket

Photobucket

Cutting ailerons.

Photobucket

Photobucket

Photobucket

Photobucket

Installing servos and servo covers.

Photobucket

Photobucket

Installed servos are Blu Bird BMS-306DMAX

Photobucket

Assembling fuselage and tail boom.

Photobucket

Installing push rods.

Photobucket

Assembling V-tail.

Photobucket

Photobucket

Photobucket

Installing tow hook.

Photobucket

Photobucket

Making pieces of lead for balancing.

Photobucket

Finishing the model.

Photobucket

Servos for elevator/rudder are 2 x Servos Blu Bird BMS-306DMAX

Power supply:

1 x Rhino 360 mAh 2s

1 x Hextronic Ubec

1 x Corona Synthesized Dual-Conv Receiver 6Ch 40Mhz

Finished model and ready for maiden flight.

Photobucket

Maiden flight was on the nearest slope. I can say that this model is more suitable for slope soaring than flat terrain. The plane is very agile and capable of aerobatics.

Photobucket

Photobucket

Photobucket

This is high quality a 60″ sailplane which can be bought in two versions, as a glider or electric sailplane. It is a perfect allrounder. It is great for slopes, high launch start or for flat terrain. The plane flies fantastic and it can even thermal. The vertical stabilizer is factory prepared for the rudder to be cut out. I bought the electric version for 220€.
The plane can be purchased here:

Mibomodeli

First I have started building the wings. I used Hitec servos as you can see on the picture below.

Photobucket

Preparing servos to be installed. Hitec HS-65MG for flaps and ailerons.

Photobucket

Photobucket

Installing servos.

Photobucket

I found that the most difficult part of the build was installing the flap servos and linkage.

Photobucket

Photobucket

Photobucket

Photobucket

Ready to put on the servo covers.

Photobucket

Photobucket

Glued the elevator horn in.

Photobucket

Horizontal stabilizer is attached to the fuselage with two metal M4 screws.

Photobucket

Elevator servo is Hitec HS-85BB.

Photobucket

And now for the power set-up.

Photobucket

Here are the links for components installed:

Turnigy Brushless Outrunner

Folding Headless Prop Spinner 35mm

Aeronaut 11×6 folding prop

Photobucket

TURNIGY K-Force 40A Brushless ESC

HXT UBEC

Rhino 1250mAh 31P 20C

Turnigy Speed Controller Programming Card

After the success of the 2.4 Ghz sistem the old one became more affordable. I bought the new Jeti REX 6 JBC receiver for Dart.

Photobucket

Maiden was a success. No trimming was needed to get this plane flying straight. Allthough not excpected the power setup gives unlimited verticals. Here are some pictures from the maiden flight. Video on the slope will follow.

Photobucket

Photobucket

Photobucket

Photobucket

Photobucket

Photobucket

Photobucket

Photobucket